Mike Wazowski Amigurumi For Monsters Inc Fans

Finished Mike Wazowski amigurumi

Finished Size: Approximately 10 inches (25 cm) tall and 7 inches (18 cm) wide

Skill Level: Beginner

Estimated Time: 2-4 hours

Hook Size: 3.5 mm

Yarn: worsted yarn

Notions: Yarn needle, stitch marker, polyfill

Gauge: Approximately 12 sc x 14 rounds = 2 inches with 3.5 mm hook

Reasons You'll Enjoy Making This

Mike Wazowski eye - white yarn detail

Welcome to a fun project that brings the one-eyed green monster from Monsters, Inc. right into your hands. This amigurumi pattern uses worsted weight yarn and a 3.5 mm hook, so the stitches stay tight and the stuffing stays inside. The finished toy measures roughly 10 inches tall and 7 inches wide, making it a perfect desk companion or gift for a Pixar fan.

If you can chain, single crochet, and work in the round, you are ready to begin. You will build the body as one large sphere, then add a single round eye patch, a small mouth, and two little legs. Each step uses simple increases and decreases, with clear stitch counts to keep your rounds balanced. The soft worsted yarn gives the finished piece a squishy, huggable feel, and the bright green color really pops against the white eye and black pupil.

Take your time, count your stitches, and enjoy watching Mike take shape one round at a time.

Gather These Supplies First

Mike Wazowski iris - green yarn detail
MaterialDetails
Yarnworsted yarn in green, white, black
Hook3.5 mm crochet hook
StuffingPolyfill or fiberfill
EyesSafety eyes or embroidery thread
ExtrasYarn needle, stitch markers, scissors

Gauge: Approximately 12 sc x 14 rounds = 2 inches with 3.5 mm hook. Not critical but aim for tight, even stitches, if stuffing shows through, go down one hook size.

Crochet Stitches in This Pattern

Note: This pattern uses US crochet terms. All rounds are worked in continuous rounds unless stated otherwise. Use a stitch marker in the first stitch of each round.

AbbreviationMeaning
scSingle crochet
incIncrease (2 sc in same stitch)
decDecrease (sc 2 together)

Step-by-Step Crochet Instructions

Mike Wazowski horn - white yarn detail

head, green yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: inc around (12)

Rnd 3: (1 sc, inc) x 6 (18)

Rnd 4: (2 sc, inc) x 6 (24)

Rnd 5: (3 sc, inc) x 6 (30)

Rnd 6: sc around (30)

Rnd 7: sc around (30)

Rnd 8: (3 sc, dec) x 6 (24)

Rnd 9: (2 sc, dec) x 6 (18)

Rnd 10: (1 sc, dec) x 6 (12)

Rnd 11: dec around (6)

Rnd 12: fasten off, close hole (6)

Switch to white yarn for the eye.

eye, white yarn

Switch to green yarn for the iris.

iris, green yarn

Use 6 mm safety eyes or embroidered eyes; place them on the upper half of the head, about one eye-width apart.

If using safety eyes, insert the posts before closing the head opening and secure the backs firmly on the inside.

If embroidering, work two small black satin stitches, then add a tiny white stitch highlight if desired.

Switch to white yarn for the horn.

horn (make 2), white yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: sc around (6)

Rnd 3: sc around (6)

Rnd 4: sc around (6)

Rnd 5: sc around (6)

Rnd 6: sc around (6)

Rnd 7: sc around (6)

Rnd 8: fasten off, close hole (6)

Switch to green yarn for the arm.

arm (make 2), green yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: inc around (12)

Rnd 3: (1 sc, inc) x 3 (2 sc, inc) x 2 (17)

Rnd 4: sc around (17)

Rnd 5: sc around (17)

Rnd 6: sc around (17)

Rnd 7: sc around (17)

Rnd 8: sc around (17)

Rnd 9: sc around (17)

Rnd 10: sc around (17)

Rnd 11: sc around (17)

Switch to white yarn for the hand.

hand (make 2), white yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: inc around (12)

Rnd 3: (1 sc, inc) x 6 (18)

Rnd 4: (2 sc, inc) x 6 (24)

Rnd 5: sc around (24)

Rnd 6: (2 sc, dec) x 6 (18)

Rnd 7: (1 sc, dec) x 6 (12)

Rnd 8: dec around (6)

Rnd 9: fasten off, close hole (6)

Switch to green yarn for the leg.

leg (make 2), green yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: inc around (12)

Rnd 3: (1 sc, inc) x 6 (18)

Rnd 4: sc around (18)

Rnd 5: sc around (18)

Rnd 6: sc around (18)

Rnd 7: sc around (18)

Rnd 8: sc around (18)

Rnd 9: sc around (18)

Rnd 10: sc around (18)

Rnd 11: sc around (18)

Switch to white yarn for the foot.

foot (make 2), white yarn

Rnd 1: 6 sc in magic ring (6)

Rnd 2: inc around (12)

Rnd 3: dec around (6)

Rnd 4: fasten off, close hole (6)

Switch to black yarn for the mouth.

mouth, black yarn

Embroider the mouth with black or dark brown thread after the eyes are placed.

Use a single curved satin stitch or back stitch, centered below the eyes and about 1.5 cm wide.

Final Stitch Counts

  • head: 30 stitches at widest point
  • eye: See pattern
  • iris: See pattern
  • horn (x 2): 6 stitches at widest point
  • arm (x 2): 17 stitches at widest point
  • hand (x 2): 24 stitches at widest point
  • leg (x 2): 18 stitches at widest point
  • foot (x 2): 12 stitches at widest point
  • mouth: See pattern

Putting the Pieces Together

1. Stuff head, hand, foot firmly with polyfill. Shape the stuffing as you go, pressing and molding to create a natural form. Add extra stuffing to the center for a rounded shape, less near the edges for a tapered look.

2. Attach eye to the head. Position on the upper half of the head, below the horns, spaced about one eye-width apart. Secure firmly with embroidery thread or fabric glue. Embroider a small line below each eye for a more expressive look.

3. Attach iris to the head. Position on the upper half of the head, below the horns, spaced about one eye-width apart. Secure firmly with embroidery thread or fabric glue. Embroider a small line below each eye for a more expressive look.

4. Sew horn to the top of the head. Position symmetrically, about 1 cm apart, angled slightly outward. Pin in place before sewing to check alignment from all angles. Use the long tail left for sewing and whipstitch around the base.

5. Sew mouth to the head. Pin in place before sewing to check positioning. Use whipstitch for a secure attachment.

6. Sew arm to the body. Position symmetrically on each side. For arms: attach at the upper third of the body, angled slightly outward. For legs: attach at the base, spaced evenly apart so the figure stands balanced. Pin in place, check from front and side views, then sew firmly with whipstitch.

7. Sew leg to the body. Position symmetrically on each side. For arms: attach at the upper third of the body, angled slightly outward. For legs: attach at the base, spaced evenly apart so the figure stands balanced. Pin in place, check from front and side views, then sew firmly with whipstitch.

8. Check all seams are secure. Gently tug each attached piece to test. Trim any loose yarn ends with sharp scissors. Weave in all remaining tails with a needle, passing through at least 3 stitches in each direction to prevent unraveling. Give the finished piece a gentle squeeze to distribute stuffing evenly and shape the final form.

Tips for a Perfect Finish and Care

Here are some practical tips and care instructions to help you finish your Mike Wazowski amigurumi with confidence.

  • Place a stitch marker in the first stitch of every round so you can easily find your starting point and keep your stitch count accurate.
  • Count your stitches at the end of each round to make sure the increases and decreases are balanced, which helps the body stay round.
  • Stuff the ball firmly as you go, adding small amounts before the opening gets too small, so the shape stays smooth and well rounded.
  • Use a 3.5 mm hook throughout the project to match the recommended gauge and keep the stitches tight enough to hide the stuffing.
  • When you decrease, work into the front loops only and pull the yarn gently to keep the surface even.
  • Leave a long tail when fastening off so you can sew the pieces together neatly with a yarn needle.

Follow these simple care steps to keep your finished toy looking its best.

  • Hand wash gently in cool water with a mild detergent, then rinse carefully without wringing.
  • Spot clean small marks with a damp cloth and a little soap instead of washing the whole toy.
  • Air dry flat on a towel away from direct sunlight to prevent the green color from fading.
  • Store in a clean, dry place to keep the shape and fibers in good condition over time.

Your Questions, Answered

What yarn weight should I use for the Mike Wazowski amigurumi?

Use worsted weight yarn for the Mike Wazowski amigurumi. This weight works nicely with the 3.5 mm hook to create a tight, sturdy fabric that holds the shape well and prevents stuffing from showing through the stitches.

How long does it take to crochet the Mike Wazowski amigurumi?

The time for this project is 2-4 hours. Most beginners finish within this range, depending on their pace and how often they pause. The simple shape keeps it a quick, satisfying make.

Is the Mike Wazowski amigurumi pattern beginner-friendly?

Yes, this pattern is rated Beginner. It uses basic stitches like single crochet and simple increases and decreases, with no advanced techniques required. If you know how to work in the round and count stitches, you can make this Mike Wazowski amigurumi.

Can I sell finished Mike Wazowski amigurumi made from this pattern?

Yes, you may sell finished Mike Wazowski amigurumi made from this pattern. Please credit the designer when listing your items online or at craft fairs. Mass production is not permitted.

Can I make the Mike Wazowski amigurumi bigger or smaller?

Yes, you can resize the Mike Wazowski amigurumi by switching yarn weight or hook size. Using a thicker yarn with a larger hook will make a bigger plush, while a finer yarn with a smaller hook creates a mini version. Just keep the hook and yarn balanced for a neat fabric.

Explore More Free Crochet Patterns

Love this pattern? Check out more free crochet patterns:

Advertisement